Hi Kevin
I have made a bridle using 3/8 floating dock rope and use carabiners
that clip on to the tow hooks on the transom. The line extends about
7'- 10' from the transom when extended in the center. I also use a
plastic float on the rope to prevent it from being sucked under when in
reverse. I then have a line that clips to the bridle using another
carabiner and through some trial and error, have the Seadoo extended
around 8-10' behind the rooster tail created from the boat. This was
fairly easy.
The one problem you will run into is the speed of your boat on plane
versus the Seadoo. The boat has a lower plane speed. I have to run my
boat faster than normal to keep the Seadoo on step. If not, the Seadoo
is a great anchor and creates lots of drag. Once you are on step the
issues are almost finished. I hardly notice the trailer being towed.
The only additional thing to remember is quick stopping. When on plane
the Seadoo stays there longer than the boat. Gradual stops are highly
recommended but this isn't too critical.
Before docking the boat, I bring the Seadoo along side opposite of the
side I am docking. I use 3 bumpers to protect my Seadoo from the
boat(or vise versa)and snug the lines to make sure the seadoo follows
the boat and isn't a hazard, especially in reverse.
It takes a bit of practice but with the correct length lines it's very
easy and everything hooks to the cleats. We have be doing this for 5
years and wouldn't go any other way.
Steve
Kevin & Debbie wrote:
> Hi Steve
> Thanks for the quick response. If you don't mind I have a few other
> questions.
> How do you tow the ski? I have seen a few methods, ranging from a tow
> rope to a "hitch" affair. The one I am thinking of copying is called the
> towdster.
<font color=purple> > <a style='text-decoration: underline;' href="http://www.towdster.com/products.htm</font" target="_blank">http://www.towdster.com/products.htm</font</a>>
> I have twin V6's so I would imagine we are in the same category re-
> loss of rpm.
> I am thinking of the Seadoo GTX RFI, or, depending on price, a newer RFI
> model. What is your opinion of Seadoos, and fuel injection compared to
> carbs.
> You mention that there were some issues regarding towing, what might
> those be?
> Again, thanks for the info. Any and all thoughts are appreciated,
> especially recommendations regarding the ski.
>
> Regards,
> Kevin
>
> SJD wrote:
>
>> Hi Kevin
>>
>> PWC insurance can range from $300-$600 a year depending on the
>> coverage. I tow my 96 Seadoo GTX (3 seater)behind my boat without
>> too many issues. I have a single big block in my cruiser and it cost
>> me around 200 RPM when the Seadoo is in tow and I'm on plane.
>> We also have a dingy that spends most of its time in storage as there
>> is no comparison. The PWC is the way to go.
>>
>> Steve
>>
>> Kevin & Debbie wrote:
>>
>>> Merry Christmas group.
>>> I was wondering if any one would know roughly how much insurance is
>>> for PWCs. I'm thinking of getting a fairly new one to tow behind the
>>> cruiser in place of the dinghy. Any suggestions for a company/broker
>>> who specializes in this type of insurance?
>>> TIA.
>>> Kevin
>>>
>>
><!-- ~MESSAGE_AFTER~ -->
>> Stay informed about: PWC insurance question