Welcome to BoatForumz.com!
FAQFAQ      ProfileProfile    Private MessagesPrivate Messages   Log inLog in

height of jib?

 
   Boat US (Home) -> Boat Building RSS
Next:  Ping: Harry  
Author Message
imagineero

External


Since: Jan 20, 2008
Posts: 3



(Msg. 1) Posted: Wed Jan 23, 2008 9:34 pm
Post subject: height of jib?
Archived from groups: rec>boats>building (more info?)

does the height of a jib off the deck on a beach cat make much
difference? Obviously the jib track needs to be moved to be in the
right spot for trimming as you put the sail higher or lower off the
deck, but are there any benfits to higher/lower?

i would have thought that a jib higher up would catch a bit more air
in light airs, but be overpowered in heavier winds... I replaced the
standing rigging on my cobra recently, but by the time i added a
furler and a new rign, the sail sits a fair bit higher than it used
to. Im thinking to re-do the rigging to bring it back down again.

Thanks,
Shaun

 >> Stay informed about: height of jib? 
Back to top
Login to vote
MMC

External


Since: Dec 09, 2007
Posts: 5



(Msg. 2) Posted: Thu Jan 24, 2008 9:37 am
Post subject: Re: height of jib? [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

I'd try what you've got before you change it. Might find that you can see
better under the sail and the better wind is higher hence the newish
tendancy to use full roach, battened main sails.
MMC

"imagineero" <imagineero RemoveThis @hotmail.com> wrote in message
news:ca20ee72-9a6c-4e4d-b7e0-a7dec33c38e8@t1g2000pra.googlegroups.com...
> does the height of a jib off the deck on a beach cat make much
> difference? Obviously the jib track needs to be moved to be in the
> right spot for trimming as you put the sail higher or lower off the
> deck, but are there any benfits to higher/lower?
>
> i would have thought that a jib higher up would catch a bit more air
> in light airs, but be overpowered in heavier winds... I replaced the
> standing rigging on my cobra recently, but by the time i added a
> furler and a new rign, the sail sits a fair bit higher than it used
> to. Im thinking to re-do the rigging to bring it back down again.
>
> Thanks,
> Shaun

 >> Stay informed about: height of jib? 
Back to top
Login to vote
Display posts from previous:   
Related Topics:
Setting your outboard up to the correct transom height. - Hi all What is the effect of raising or lowering the outboard motor on the transom? All outboard motors are built to suit 20"or 25" transom heights etc, but if the motor is set slightly higher or lower what is the effect on boat performance. I...

height and placement of red and green side lights - http://www.boatsafe.com/nauticalknowhow/sidelights.htm This site says lights below the rub rail are illegal according inland rules of navigation "Additionally, most of these flush mounted sidelights are installed below the vessel's rub rail...

outboard height on a pod & cavitation plate angle - hi there, I have been rebuilding a 6-meter fibreglass boat off and on over the last four years, and I am nearly there. I have just purchased a Suzuki DF140 to mount on the pod that is fitted. I read that you should raise the cavitation plate 1" ...

Lovett Or Rule - I ask....Lovett Or Rule?

Lapstrake dinghy made from foam ???? - Am contemplating a large lapstrake dinghy (wherry) made from styrofoam sheet and FRG ... as a male plug - in the manufacturing fashion of a surfboard. The obvious attempt would be to keep the boat in the ultra-light range. The sanding, finishing of a...
   Boat US (Home) -> Boat Building All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]